Step-by-Step Process to Attach a Hydraulic Reversible MB Plough to Your Tractor

J. Finesse
Nov 15
2 min read

Attaching a hydraulic reversible MB plough correctly is essential for safe operation, proper soil penetration, and long-term performance. A small mistake in the setup can cause accidents, reduce traction, or damage both the plough and tractor. This quick guide explains the essential steps to prepare your tractor and attach the plough safely and efficiently.

🚜 1. Know Your Hydraulic Reversible MB Plough

An MB plough turns, breaks, and mixes soil to prepare deep and healthy seedbeds. The hydraulic reversible type from Ashok Metal Works works deeper than standard tillage tools and ensures uniform soil inversion with minimal operator effort. Correct attachment ensures better traction, higher field efficiency, and lower fuel consumption.

⚙️ 2. Prepare the Tractor Before Attachment

A well-prepared tractor ensures stable, efficient ploughing.

Wheel Alignment: Front and rear tyres must align in the same furrow.
Ballast: Increase rear wheel weight using wheel weights or 75% water + 25% air fill.
Hydraulics: Clean SCVs and ensure the auxiliary kit is functioning properly.
3-Point Linkage: Lower links must be at equal height for a level attachment.
Control Settings: Set load/depth control as per the tractor’s operator manual.

🔧 3. Step-by-Step Attachment Guide

Step 1 — Level Ground Setup

Park the tractor and plough on the same ground level for proper attachment.

Step 2 — Reverse and Connect

Reverse the tractor slowly and align the 3-point linkage with the plough frame.

Step 3 — Attach Lower Links First

Attach the left lower link and secure it with the pin. Attach the right (adjustable) lower link next. Finally, connect the top link.

Step 4 — Align the Plough

Use the right adjuster link to keep the plough parallel to the ground and aligned with the working width.

Step 5 — Set Draft Sensing

Place the top link pin:

Lower hole → hard soil
Upper hole → light soil(Check manual — draft sensing holes vary by tractor model.)

Step 6 — Adjust Top Link Length

Tilted backwards → shorten top link
Tilted upwards → lengthen top link

Step 7 — Check Leg Angle

From behind, the leg assembly should stand 90° to the ground.

Step 8 — Pull Line Adjustment

The pull line (between lower link center and plough cutting edge) should pass through the rear axle center. If not: Adjust the inner turnbuckle to ensure the tractor moves straight without pulling to either side.

Step 9 — Ready to Work

Your Ashok Metal Works plough is now aligned, balanced, and ready for field operations.

🌾 Built for Bharat’s Fields

A correctly attached plough improves output, saves diesel, and reduces wear.Choose the Hydraulic Reversible MB Plough from Ashok Metal Works — engineered for durability, above 20 inches working depth, and compatible with tractors above 60 HP.

📞 +91 94251 49002🌐 www.ashokmetalworks.com📍 Jatrapura, behind Ram Leela Maidan, Vidisha, Madhya Pradesh 464001🇮🇳 Made in Bharat